Lollipop 5.1 CM 12.1 Custom ROM For Samsung Galaxy Note 3

Lollipop 5.1 CM 12.1 Custom ROM For Samsung Galaxy Note 3

galaxy-note-3-Lollipop

 

Disclaimer:  We Have Not Responsible, If You Brick Your Phone Or SD Card Dead Or Your Phone Is Not Working Properly. It Is Your Own Responsibility And Your Own To Update Your Devices

The Lollipop Android5.1 Samsung Galaxy Note 12.1 Support Of Cm Rom Customization On Note 3 (N9002, N9005, N9006, N9008, N9008s, N9008v And Note 3 Of The Canadian Version) Multiple Models.

Since This Is A Custom Rom Cyanogenmod It May Have Some Errors. However, When We Tested It, We Found That The Basic Functions Of Smart Phones Are Working Properly. In Addition, We Want To Tell You, If You Do Not Follow Instructions Carefully And Flashing Rom, You May End Up Masonry Your Device. Therefore, Follow All Instructions Carefully. Equipment Damage Or Brick Is Not Our Responsibility.

Update  preparation

1. Backup Your Phone
2. Your Phone’S Battery Should Be Charged 80% Of The Minimum.

3.Need Install Adb Driver

4.Enable usb debugging Go

Settings > About Phone > Build number > Tap it 7 times to become developer;
Settings > Developer Options > USB Debugging.

5.Your Device Need Root, Need Install Custom Recovery Go Here Xda Thread For  Root Twrp 

6. Let Your Computer Must Correct Power Backup.

7. Download Rom And Gaaps
8. Read All The Steps, And Then Do It Carefully

Download Rom And Gaaps

[sociallocker]

Rom

Gapps

[/sociallocker]

How To Install Lollipop On Note 3

 

  • Connect Your Note 3 To The Pc.
  • Copy The 2 Downloaded Files ( “Android Lollipop 5.1 Cm 12.1 Custom Rom” And “Gapps” ) In The Root Folder On Your Device.
  • Disconnect Your Device From Pc.
  • Switch Off Your Device.
  • Boot Into Recovery Mode By Pressing Volume Up + Home + Power Buttons
  • Use Volume Keys To Navigate In Recovery Mode And Power Button To Select
  • Now Make A Backup Of Stock Rom By Clicking “Back Up And Restore”And From There Choose “Back Up”.
  • In The Recovery Mode Choose “Wipe Data/Factory Reset” And The System Will Perform A Full Data Wipe.
  • Now Choose “Wipe Cache Partition” And System Will Perform A Wipe Cache Partition Process.
  • Now Perform A Wipe Dalvik Cache Partition. For Doing This Go To “Advanced -> Wipe Dalvik Cache”.
  • Go Back To The Main Recovery Menu And Select “Install Zip From Sd Card”.
  • From There , Choose Android Lollipop 5.1 Cm 12.1 Custom Rom And Press Power Button To Flash It.
  • Again Go Back To Main Recovery Menu And Select “Install Zip From Sd Card” And Choose “Gapps”. Press Power Button To Flash It.
  • Now Go Back To Main Recovery Menu And Select Reboot System Now.
  • First Boot Will Take About 5-10 Minutes

 

Also Read  [Firmware] Official Lollipop Stock Rom For Lenovo A6000/Plus
Comments
62 Shares
Share
+1
Tweet
Pin